en:x300:spindle_test_key
This is an old revision of the document!
Spindle Test
The Spindle Test will test the controller output to the Spindle Motor. The spindle motor will stay active until the key is pressed again.
Activating Spindle Test
Press the SPINDLE TEST key.
Keypad Display “Activating Spindle ….”
Press SPINDLE TEST again stops the Spindle Test.
Note:
Pressing the CANCEL 
key will also stop the spindle test.
en/x300/spindle_test_key.1664310769.txt.gz · Last modified: 2022/09/27 22:32 by erik.ketele
