en:x300:spindle_not_rotating
This is an old revision of the document!
The spindle does not rotate
Check the following:
1. Is there a timing belt between the spindle motor pulley and the spindle pulley ?
2. Does your virtual pendent on the computer screen show a cutter with a “green arrow” ? 
. If it shows a red arrow 
,the spindle will not rotate.
Continue to trouble shooting, the engraving results are poor.
Continue to the table of contents.
en/x300/spindle_not_rotating.1664375175.txt.gz · Last modified: 2022/09/28 16:26 by erik.ketele
