en:x300:move_back-forward_x_times
This is an old revision of the document!
Move back / Move forward x times
 | ]] | If you push this key during an engraving job, the spindle will lift and move back either one vector or one character, depending upon the software used. |
| | If you push this key during an engraving job, the spindle will lift and move back either ten vectors or ten characters, depending upon the software used. |
| | If you push this key during an engraving job, the spindle will lift and move back either 25 vectors or 25 characters, depending upon the software used. |
| | If you push this key during an engraving job, the spindle will lift and move forward either one vector or one character, depending upon the software used. |
| | If you push this key during an engraving job, the spindle will lift and move forward either ten vectors or ten characters, depending upon the software used. |
| | If you push this key during an engraving job, the spindle will lift and move forward either 25 vectors or 25 characters, depending upon the software used. |
en/x300/move_back-forward_x_times.1664093239.txt.gz · Last modified: 2022/09/25 10:07 by erik.ketele
