On the image on the right, the green rectangle indicates the cover which has to be removed.

The X-300 has to be connected to a computer on which the virtual pendent software is configured and registered.

Switch on machine and computer.

Home the spindle, then, using the jog keys, move the spindle to approximately the middle of the X-axis and all the way to the front of the machine (see image on the right below).

Next, switch off the machine.

Remove the M4 screw with the black plastic cover support, indicated by a yellow arrow.

Remove the M4 buttonhead screws, indicated by a green arrow.

Remove the M4 buttonhead screw, indicatedbya blue arrow. Be careful not to mix the screws indicated with a green arrow with the one indicated with a blue arrow. The one indicated with a blue arrow is shorter and must be replaced on the same spot when re-assembling.

Put all of these screws in a safe space.

Slide the left Y-axis belt cover off and put it away together with the screws.

Remove the M4 screw with the black plastic cover support, indicated by a yellow arrow.

Remove the M4 buttonhead screws, indicated by a green arrow.

Remove the M4 buttonhead screw, indicated by a blue arrow. Be careful not to mix the screws indicated with a green arroww with the one indicated with a blue arrow. The one indicated with a blue arrow is shorter and must be replaced on the same spot when re-assembling.

Put all of these screws in a safe space.

Slide the right Y-axis belt cover off and put it away together with the screws.