en:x200:box_contents
This is an old revision of the document!
Table of Contents
2.2 Unpack the machine and check the contents of the box
Unpacking
- Place the box on the floor, near the table or workbench where you want to install the machine
- Open the box
- Gently take out the machine and the accessories and place them on your tabletop or benchtop.
- Check the contents of your delivery using the checklist in the paragraph below.
- Clear your tabletop or benchtop and store all accessories in the vicinity.
- Attention: it is a 2 person job! to lift the machine out of the box and place it on the workbench or table.
After having unpacked, we advise you not to throw away the packing material. You might need it later when you need to move the machine to a new location or eventually, to ship the machine back to your vendor for service or repair.
Check the contents of the box
| Afbeelding | Omschrijving | Aantal | Checkbox |
|---|---|---|---|
 | Graveermachine Cyborg X-200 | 1 | |
 | Frees 3.175 mm x 125 mm, graveerbreedte 0.2 mm | 1 | |
 | Spanknop 3.175 mm | 1 | |
 | Vacuümslang 2 m | 1 | |
 | Inbussleuteltje voor spanknop (2 mm) | 1 | |
 | Voedingskabel | 1 | |
 | CAT6A ethernet kabel | 1 | |
 | USB stick met software en registratiecode voor Pendent software en voor Symmetry graveersoftware | 1 | |
 | Zelfklevende mat 200 mm x 150 mm | 1 | |
 | kabel voor automatisch aan- en uitschakelen van een stofzuiger (let op: uitgang 5 VDC) | 1 |
Ga verder naar de X-200 kabelaansluitingen.
Ga verder naar inhoudstafel.
en/x200/box_contents.1744894776.txt.gz · Last modified: 2025/04/17 14:59 by erik.ketele
