====== Move to XYZ-coordinate ======

The MOVE command allows you to enter exact values for X, Y, or Z (0,0,0) where the first entry is X, the second entry is Y, and the third entry is Z. \\
The X, Y, and Z values will reference from the machine’s Hard Home position until the SET HOME and SET SURFACE commands have been selected.\\ 
At that point the X and Y axis will reference from the Set Home position. The Z value will reference from the surface of the material if the surface has been set.

To Move To A Specific Location.

Press the MOVE hot key.\\
Enter the desired value for X from the number pad (50.0 for example).\\
{{:en:x200:movetoxyz-x.png?200}}\\
Press ENTER to accept the value.

Enter the desired value for Y from the number pad (-50.0 for example). Press ENTER to accept the value.\\
{{:en:x200:movetoxyz-y.png?200}}

Enter the desired value for Z from the number pad (5.0 for example). Press ENTER to accept the value.\\
{{:en:x200:movetoxyz-z.png?200}}

When the coordinates have been entered, click on the **Move** button.\\
{{:en:x200:movetoxyz-move.png?200}}\\
When pushing the **Move** button the machine will move to the new coordinates. If for some reason you do not want to move to the entered coordinates, hit the **Cancel** key.\\ \\
After the move you will see the new coordinates in the top part of the pendent window:\\
{{:en:x200:movetoxyz-coord.png?300}}\\

\\
**Return to [[:en:x200:keypad_overview|the keypad overview]].** \\
**Continue to [[:en:x200:table_of_contents|the table of contents]].**