====== 3.4.2. Engraving without floating nosecone ======

- In this chapter we explain how the plate surface (Z=0.0) can be defined (see 3.4.2.1).\\
- Then you will read which procedure has to be followed to enter engraving depths in Symmetry. (see 3.4.2.2.)\\
- After that follows the explanation how to mechanically prepare the machine to work without nosecone. (see 3.4.2.3.)\\
- Finally the execution of the engraving job with locked spring pressure. (zie 3.4.2.4.)

  * [[:en:x200:define_z-offset_when_surfacing|3.4.2.1. Defining the plate surface]]
  * [[:en:x200:how_to_use_symmetry_engraving_depths|3.4.2.2. How to enter engraving depths in Symmetry]]
  * [[:en:x200:how_to_lock_the_spring_pressure|3.4.2.3. Locking the spindle spring to engrave without nosecone]]
  * [[:en:x200:executing_a_job_without_nosecone|3.4.2.4. Executing a job without using the nosecone]]

**Continue to [[:en:x200:define_z-offset_when_surfacing|3.4.2.1. Defining the plate surface]].** \\ **Continue to [[:en:x200:table_of_contents|the table of contents]].**