,===== Vacuum cleaner for dust extraction =====

{{:nl:x200:vacconnect.png?600}}\\
\\
The Cyborg X-200 should always be used with a dust extractor.\\
The X-200 controller can switch a vacuum cleaner on and off automatically at the beginning and at the end of an engraving job.\\
To do so there is a dedicated 5 VDC outlet at the rear of the machine.\\ 
In the above image this is the black plug with the red and black wire. \\
Do only use a solid state relay.\\
\\
{{:en:x300:stofzuiger-groen.jpg?60}} If this icon is shown on the virtual pendent, the vacuum cleaner outlet will be powered.\\
{{:en:x300:stofzuiger-rood.jpg?60}} If this icon is shown on the virtual penden, the vacuum outlet will not be powered.\\
\\
{{:en:x300:dsc_9147.png?300}}\\
Every X-200 comes with a short cable with plug to put in the "dust collector" outlet.\\
The purpose is to switch on and off a 5 VDC solid state relay which in turn can switch a vacuum cleaner on and off.\\
\\
Clicking on the icon will alternate between the 2 possible choices.

**Return to [[:en:x200:keypad_overview|the keypad overview]].** \\
**Continue to [[:en:x200:table_of_contents|the table of contents]].**