====== Installing the Cyborg Pendent Software on a standalone pc with a fixed IP-address. ======

Note: If you are not familiar with setting up Ethernet connections, you should get help from a qualified IT-specialist.

==== Preparations ====

  - Connect the Cyborg X-300 with the pc by means of the supplied Ethernet cable, or another CAT 6A ethernet cable.
  - Put the power cable in the machine’s power socket and then in the wall outlet.
  - Switch on the Cyborg X-300’s main switch.
  - Boot your computer as administrator with full administrator rights.
  - Make sure all firewalls and virus scanners are disabled.
  - Give your pc the following fixed IP-address: 172.22.2.101. Our Cyborg machine is preprogrammed with the following fixed IP-address: \\ 172.22.2.100 and the following netmask: 255.255.255.0.
  - Put the usb stick which was supplied with the Cyborg X-300 in the pc.
  - Create a folder on your C-drive, and name it “Cyborg”.
  - Copy the file "CyborgPendent-0.0.xx_x64.exe" file in the “Cyborg” folder.

===== Installation =====

|{{:en:x300:installatie-1.png?400  |{afbeelding}}| \\ - Doubleclick on the "CyborgPendent-0.0.xx_x64.exe" file to start the installation procedure. \\ When you run this file for the first time you will see a window similar to this one: \\ - Click the “Next” button.- After a few seconds you will see the following window on your pc screen:|
|{{:en:x300:installatie-2.png?400  |{afbeelding}}|- Click the “install” button, the software installs itself and at the end of the installation procedure you will see the following window:|
|{{:en:x300:installatie-3.png?400  }}|- Then click the “Close” button. Your Cyborg machine software is now fully installed.|

----

**Continue to [[:en:x300:pendent_registration|registering the virtual pendent software]].** \\ **Continue to [[:en:x300:table_of_contents|the table of contents]].**