cyborg-engravers

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Move to XYZ-coordinate ======

The MOVE command allows you to enter exact values for X, Y, or Z (0,0,0) where the first entry is X, the second entry is Y, and the third entry is Z. The X, Y, and Z values will reference from the machine's Hard Home position until the SET HOME and SET SURFACE commands have been selected. At that point the X and Y axis will reference from the Set Home position. The Z value will reference from the surface of the material.

To Move To A Specific Location.

Press the MOVE   hot key.
Keypad Display:
 " Move To "
 " X ###.#### "

Enter the desired value for X from the number pad (50.0 for example).
Press ENTER   to accept the value. 

Keypad Display:
   " Move To "
   " X ###.#### " 
   " Y ###.#### "

Enter the desired value for Y from the number pad (-50.0 for example). Press ENTER   to accept the value. 

Keypad Display:
  " Move To "
  " X ###.#### " 
  " Y ###.#### "
  " Z ###.#### "

Enter the desired value for Z from the number pad (-2.0 for example). Press ENTER   to accept the value. 

Keypad Display:
  " Move To "
  " X ###.#### "
  " Y ###.#### "
  " Z ###.#### " " ? "

When the "?" is displayed, press ENTER   to accept all settings and move the machine to the new coordinates.
The above steps will be repeated until you press the CANCEL   hot key to return the Main Display.
 
=== Note: ===

When the X, Y, or Z value comes up it will be in the current location of that axis. If the current location is required select MOVE   and Press ENTER  three times. This will display the current location. To keep an axis from moving Press ENTER  when the axis value comes up.
cyborg-engravers

User Tools

Site Tools

Page Tools
