cyborg-engravers

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Switching the power on and off ======

==== Switching on ====

|**Before switching on the power, make sure the power cord is properly seated in the power inlet socket of the machine and on the other end in a well grounded power outlet socket.**  |

{{:en:x300:switch-on.jpg?200 |}}To switch on the power you toggle the rocker switch at the rear of the machine to the I position. (see image on the left.) It is not important in which order you switch on the machine and the program on the PC.
\\ \\ 

----

==== Switching off ====

|**Before switching off the power, make sure the machine is not still running.**   |

{{:en:x300:switch-off.jpg?200  |switch-off.jpg}}To switch off the power you toggle the rocker switch at the rear of the machine to the 0 position. (see image on the left.) It is not important in which order you switch off the machine and the program.

----

**Continue to [[:en:x200:fixing_engraving_material|fixing the engraving material to the table]].**\\
**Continue to [[:en:x200:table_of_contents|the table of contents]].**

cyborg-engravers

User Tools

Site Tools

Page Tools