cyborg-engravers

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Securing the engraving material onto the engraving table ======

There are different ways to secure the material to the engraving table. Below, you will find a list of the different possibilities. It is up to you to choose which option is more appropriate for your application.

==== Using the standard included flat engraving table ====

Every Cyborg X-200 is shipped standard with this table. The engraving table has two stops, one on the left and one on the rear. The standard home position for any plate on this table is its upper left corner. The table stops can be positioned higher or lower, depending upon the thickness of the material to be engraved.

==== Using the standard "Multimat" sheet ====

{{:en:x300:seklema_mat.jpg?600|multimat}}

To secure the engraving material to this table you first have to put the sticky “Multimat” (standard included) on the engraving table. You then put the engraving material on the Multimat. The Multimat has 2 sticky sides. It will firmly hold the engraving material to the engraving table.

==== Using the optional quicklock vise ====

{{:en:x200:dsc03906.jpg?600|Quicklock vise X-200}}

The quick lock vise can be placed on the standard flat engraving table. Using 4 fixing screws it is secured to the left and the right side of the engraving table. This vise can be equipped with different clamping bars.

**Continue to [[:en:x200:tool_setup|setting up a tool]].** \\
**Continue to [[:en:x200:table_of_contents|the table of contents]].**

cyborg-engravers

User Tools

Site Tools

Page Tools