Differences

This shows you the differences between two versions of the page.

--- en:x300:switching_on_off [2022/09/21 11:55]
erik.ketele [Switching off]
+++ en:x300:switching_on_off [2023/05/17 10:05] (current)
@@ Line 3: / Line 3: @@
 ==== Switching on ====
-{{ :user:jan.vangelder:x300:en:100x50.png?300|}}
 |**Before switching on the power, make sure the power cord is properly seated in the power inlet socket of the machine and on the other end in a well grounded power outlet socket.**  |
@@ Line 12: / Line 11: @@
 ==== Switching off ====
-[[:user:jan.vangelder:x300:en:100x50.png?id=en:x300:switching_on_off&media=user:jan.vangelder:x300:en:100x50.png|{{  :user:jan.vangelder:x300:en:100x50.png?nolink&300}}]]
 |**Before switching off the power, make sure the machine is not still running.**   |
-{{:en:x300:switch-off.jpg?200  |switch-off.jpg}}To switch off the power you toggle the rocker switch at the rear of the machine to the 0 position. (see image on the right.) It is not important in which order you switch off the machine and the program.
+{{:en:x300:switch-off.jpg?200  |switch-off.jpg}}To switch off the power you toggle the rocker switch at the rear of the machine to the 0 position. (see image on the left.) It is not important in which order you switch off the machine and the program.
 ----
-**Continue to [[fixing_engraving_material|fixing the engraving material to the table]].**\\
+**Continue to [[:en:x300:fixing_engraving_material|fixing the engraving material to the table]].**\\
 **Continue to [[:en:x300:table_of_contents|the table of contents]].**

cyborg-engravers

User Tools

Site Tools

Differences

Page Tools