en:x300:start
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x300:start [2022/05/18 10:29] jan.vangelder [Cyborg X-300 Desktop Engraver - User's Manual] |
en:x300:start [2023/05/17 10:05] (current) |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| ---- | ---- | ||
| + | |||
| ==== Introduction ==== | ==== Introduction ==== | ||
| Line 16: | Line 17: | ||
| Please note, although the author of this manual made their best efforts to give an accurate description of the operation of this machine, evolutions in technology and software may cause specific details to be inaccurate. The contents of this manual are therefore subject to changes without notice. | Please note, although the author of this manual made their best efforts to give an accurate description of the operation of this machine, evolutions in technology and software may cause specific details to be inaccurate. The contents of this manual are therefore subject to changes without notice. | ||
| - | ----- | + | ---- |
| ==== Legal notices ==== | ==== Legal notices ==== | ||
| Line 22: | Line 23: | ||
| All brands, tradenames, product names and registered trademarks used in this manual are the property of their respective owners. | All brands, tradenames, product names and registered trademarks used in this manual are the property of their respective owners. | ||
| - | Copyright © 2020 Ketele NV (https:// | + | Copyright © 2020 Ketele NV ([[https:// |
| Copying this manual, except for personal use, is strictly prohibited without the explicit written approval of the author. | Copying this manual, except for personal use, is strictly prohibited without the explicit written approval of the author. | ||
| - | ----- | + | ---- |
| + | |||
| + | **Continue to [[: | ||
| + | **Continue to [[: | ||
| - | **Continue to [[safety_instructions|the safety instructions and the table of contents]].** | ||
en/x300/start.1652862572.txt.gz · Last modified: 2022/05/18 10:29 by jan.vangelder
