Differences

This shows you the differences between two versions of the page.

--- en:x300:spindle_pressure_spring [2022/09/21 21:15]
erik.ketele
+++ en:x300:spindle_pressure_spring [2023/05/17 10:05] (current)
@@ Line 1: / Line 1: @@
-====== Using the spindle pressure spring ======
+==== Using the spindle pressure spring ====
 \\
 {{:en:x300:pressure_nut.jpg?200|pressure_nut.jpg}}
-<code>
 ==== Locking the pressure spring for engraving without depth regulator nose ====
-</code>
+If you want to engrave without nosecone, e.g. after having performed a surface map, or when cutting a 3d relief, the spring pressure ring has to be locked. To lock the spring pressure ring, it has to be screwed down completely.\\
+{{:en:x300:spindle_pressure_ring_up.jpg?300|spindle_pressure_ring_up.jpg}}This image shows the spindle pressure ring in the up position (unlocked).\\
-If you want to engrave without nosecone, e.g. after having performed a surface map, or when cutting a 3d relief, the spring pressure ring has to be locked. To lock the spring pressure ring, it has to be screwed down completely. {{:en:x300:spindle_pressure_ring_up.jpg?300|spindle_pressure_ring_up.jpg}}This image shows the spindle pressure ring in the up position (unlocked). {{:en:x300:spindle_pressure_ring_down.jpg?300|spindle_pressure_ring_down.jpg}}This image shows the spindle pressure ring in the down position (locked).
+{{:en:x300:spindle_pressure_ring_down.jpg?300|spindle_pressure_ring_down.jpg}}This image shows the spindle pressure ring in the down position (locked).\\
 |**Note:** Be extremely careful never to use the nosecone on your spindle when the spring pressure lockring is down. You may harm your Z-axis motor, the Z-axis leadscrew and even the controller. In other words, always respect the following principle: Never launch an engraving cycle with both the nosecone on the spindle and the spring pressure lock ring screwed down.  |

cyborg-engravers

User Tools

Site Tools

Differences

Page Tools