en:x300:spindle_not_rotating
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x300:spindle_not_rotating [2022/09/28 16:21] erik.ketele |
en:x300:spindle_not_rotating [2023/10/20 12:19] (current) jan.vangelder |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ===== The spindle does not rotate ===== | ===== The spindle does not rotate ===== | ||
| + | |||
| + | ---- | ||
| Check the following: | Check the following: | ||
| \\ | \\ | ||
| - | 1. Is the power cord connected | + | 1. Is there a timing belt between |
| - | 2. Does your wall outlet supply power? Did you measure it with a multimeter | + | 2. Does your virtual pendent on the computer screen show a cutter |
| - | 3. Are the two glass fuses inside the main filter still OK? They sit just near the power cord socket. Check them with an Ohm-meter.\\ | + | |
| - | 4. When switching on the machine, do you hear the fan and do you hear the motors locking? | + | |
| - | 5. If the power switch is OK, the 48 VDC power supply might be defective. It feeds the fan and the step drives.\\ | + | |
| - | 6. With the protective cover OPEN, and trying to home the spincle | + | |
| - | 7. If you see this image and the machine does still not look for its home when pushing {{: | + | |
| - | **Continue to [[spindle_not_rotating|trouble shooting, | + | **Continue to [[poor_engraving_results|trouble shooting, |
| **Continue to [[: | **Continue to [[: | ||
en/x300/spindle_not_rotating.1664374879.txt.gz · Last modified: 2022/09/28 16:21 by erik.ketele
