cyborg-engravers

User Tools

Site Tools

Trace: • spindle_pressure_spring • monthly • option_flush_layout
en:x300:spindle_belt_replacement

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
en:x300:spindle_belt_replacement [2022/09/28 14:07]
erik.ketele 		en:x300:spindle_belt_replacement [2025/04/20 12:05] (current)
erik.ketele
Line 1: Line 1:
 ===== Replacing the spindle belt ===== ===== Replacing the spindle belt =====
-\\ + 
-**__Important notes:__**\\ +---- 
-  - Since the belt between the spindle motor and the spindle is a timing belt, it is not necessary to tension the belt.The teeth on the belt will prevent slipping and hence loss of rpms. + 
-  - The advantage of a non tensioned belt is also that the spindle motor bearings are not put under sideways pressure. +**__Important notes:__ ** 
-{{:en:x300:remove_belt.png?1200|}}\\ + 
-1. Spindle with cutter and cutter knob\\ +   - Since the belt between the spindle motor and the spindle is a timing belt, it is not necessary to tension the belt.The teeth on the belt will prevent slipping and hence loss of rpms. 
-2. spindle with cutter and cuuter knob removed\\ +  - The advantage of a non tensioned belt is also that the spindle motor bearings are not being put under lateral pressure. 
-3. Rotate spindle clockwise and simultaneously move the belt up on the spindle pulley\\ + 
-4. Finally the timing belt will come off the spindle pulley.\\+{{:en:x300:dsc_9155.jpg?600|ASCII}} \\  \\ On the above image it is clearly visible that there is no strain on the timing belt. \\  \\ Follow the 4 steps below to take off the timing belt from the spindle. \\  \\ {{:en:x300:remove_belt.png?1200}} \\ 1. Spindle with cutter and cutter knob \\ 2. spindle with cutter and cuuter knob removed \\ 3. Rotate spindle clockwise and simultaneously move the belt up on the spindle pulley \\ 4. Finally the timing belt will come off the spindle pulley. \\  \\ When putting on a new belt, first put it around the spindle motor pulley, then rotate it clockwise over the spindle pulley. 
 + 
 +**Continue to [[:en:x300:timing_belt_tensioning|tensioning the timing belts]].** \\ **Continue to [[:en:x300:table_of_contents|the table of contents]].**
  
  
-**Continue to [[:en:x300:configuring_the_pc_ethernet_port|Configuring the pc ethernet port]].** \\ 
-**Continue to [[:en:x300:table_of_contents|the table of contents]].** 
en/x300/spindle_belt_replacement.1664366866.txt.gz · Last modified: 2022/09/28 14:07 by erik.ketele

Page Tools

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki