Differences

This shows you the differences between two versions of the page.

--- en:x300:shift_set_home_key [2022/09/25 12:58]
erik.ketele
+++ en:x300:shift_set_home_key [2023/05/17 10:05] (current)
@@ Line 12: / Line 12: @@
 **Return to last home after machine reboot.**
-When using this key combination the X and Y coordinate fields in the virtual pendent will no longer show the 0.00 mm coordinate.\\
+When using this key combination the spindle will return to the last used origin, even if this origin was not explicitly saved.\\
-Instead you will see the coordinates count between the machine origin and the spindle position above the engraving table.\\
+Returning to last job origin. Press the SHIFT {{:en:x300:key_shift.png?20}}and then the SET HOME {{:en:x300:key_sethome.png?20}}hot keys.\\
-Returning to Machine Home. Press the SHIFT {{:en:x300:key_shift.png?20}}and then the SET HOME {{:en:x300:key_sethome.png?20}}hot keys.\\
-Then push {{:en:x300:key_gohome.png?20}}to make the spindle return to the machine home.

cyborg-engravers