Differences

This shows you the differences between two versions of the page.

--- en:x300:shift_lower_spindle_key [2022/09/25 21:47]
erik.ketele
+++ en:x300:shift_lower_spindle_key [2023/05/17 10:05] (current)
@@ Line 1: / Line 1: @@
 ====== Move spindle down 1 mm=======
-{{:en:x300:key_shift.png?50|}}{{:en:x300:key_zdn.png?50|}}\\
+{{:en:x300:key_shift.png?50|}} {{:en:x300:key_zdn.png?50|}}\\
-Press and hold the Z-AXIS JOG ARROW {{:en:x300:key_zdn.png?30|}} to lower the spindle.\\
+\\
-Use the jog speed bar to change the speed {{:en:x300:snail-rabbit.jpg?200|}}. Click on the rabbit or on the turtle, or click on the dial.
+Press the SHIFT {{:en:x300:key_shift.png?20|}} key and then the Z-AXIS JOG DOWN ARROW {{:en:x300:key_zdn.png?20|}} to lower the spindle exactly 1 mm.\\
+This key combination can be used several times one after the other.  Each time the spindle will lower  mm.
 \\
 **Return to [[keypad_overview|the keypad overview]].**\\
 **Continue to [[:en:x300:table_of_contents|the table of contents]].**

cyborg-engravers