Differences

This shows you the differences between two versions of the page.

--- en:x300:setting_saving_origin_points [2022/09/22 12:14]
erik.ketele
+++ en:x300:setting_saving_origin_points [2023/05/17 10:05] (current)
@@ Line 60: / Line 60: @@
 === Recalling the last softhome after machine reboot ===
-To reactivate call a previously recorded programmable home position, click the {{:en:x300:zero.png?30|}} key. The "Go to home number" window appears. When you click on one of the nine available keys, the spindle will move to that specific home position and the virtual pendent will display the number of the active home position in the upper right corner of the Cyborg virtual pendent.
+If you have used a soft home, then switched off the machine, or if you had a power fail, and you reboot the machine, it is still possible to recall the last used soft home from before the reboot.  This can only be done if after the reboot no new soft home was determined.  To recall the last used soft home, click {{:en:x300:key_shift.png?20|}} and then {{:en:x300:key_sethome.png?20|}}.
+**Continue to [[choosing_z_modes|choosing Z modes]].**\\
 **Continue to [[:en:x300:table_of_contents|the table of contents]].**

cyborg-engravers