Differences

This shows you the differences between two versions of the page.

--- en:x300:setting_saving_origin_points [2022/09/22 12:12]
erik.ketele
+++ en:x300:setting_saving_origin_points [2023/05/17 10:05] (current)
@@ Line 58: / Line 58: @@
 When one of the preprogrammed origins is recalled, this origin also becomes the new soft home, and replaces the possibly existing soft home. After switching off the machine and rebooting it, the machine home becomes the origin point again, but the preprogrammed origins (1-9) remain in the machine's memory and can be reactivated any time.
+=== Recalling the last softhome after machine reboot ===
+If you have used a soft home, then switched off the machine, or if you had a power fail, and you reboot the machine, it is still possible to recall the last used soft home from before the reboot.  This can only be done if after the reboot no new soft home was determined.  To recall the last used soft home, click {{:en:x300:key_shift.png?20|}} and then {{:en:x300:key_sethome.png?20|}}.
+**Continue to [[choosing_z_modes|choosing Z modes]].**\\
 **Continue to [[:en:x300:table_of_contents|the table of contents]].**

cyborg-engravers