Differences

This shows you the differences between two versions of the page.

--- en:x300:set_surface_key [2022/09/28 14:46]
erik.ketele
+++ en:x300:set_surface_key [2023/05/17 10:05] (current)
@@ Line 12: / Line 12: @@
 \\
 \\
+----
 \\
 {{:en:x300:plate_surface_set_v2.png?200|}}\\
 \\
 Press the JOG ARROWS keys {{:en:x300:key_left.png?20}}{{:en:x300:key_right.png?20}}{{:en:x300:key_up.png?20}}{{:en:x300:key_dn.png?20}} to position the cutter anywhere over the material.\\
-Press the SURFACE {{:en:x300:key_surface.png?20}} key.\\
+Press the SURFACE {{:en:x300:key_surface.png?20}} key. This will open the following window:\\
-{{:en:x300:set_surface.jpg?200|}}
+{{:en:x300:set_surface.jpg?200|}}\\
+\\
+. You can now (continuously) push the probe button {{:en:x300:probe.jpg?150|}}. The spindle will slowly move down and set the plate surface.\\
+. Or you can manually move the spindle down {{:en:x300:key_zdn.png?20|}} till it just touches the material surface and hit the Enter {{:en:x300:key_enter.png?20|}} key in the set surface window.\\
+\\
+----
+{{:en:x300:plate_surface_map_v2.png?200|}}\\
+\\
+Press the JOG ARROWS keys {{:en:x300:key_left.png?20}}{{:en:x300:key_right.png?20}}{{:en:x300:key_up.png?20}}{{:en:x300:key_dn.png?20}} to position the cutter on the upper left corner of the imaginary rectangle of which you want to scan the relief.\\
+Press the SURFACE {{:en:x300:key_surface.png?20}} key. This will open the following window:\\
+{{:en:x300:surface_map.jpg?350|}}\\
+\\
+Fill in the data as you like. You can read further information in the bottom part of **[[spindle_pressure_spring|this page]]**\\

cyborg-engravers

User Tools

Site Tools

Differences

Page Tools