en:x300:set_home_key
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x300:set_home_key [2022/09/25 11:34] erik.ketele |
en:x300:set_home_key [2023/05/17 10:05] (current) |
||
|---|---|---|---|
| Line 14: | Line 14: | ||
| * Keypad Display "Home 0 Set." | * Keypad Display "Home 0 Set." | ||
| - | === Notes: === | + | === Note: === |
| The software reference point must be the material Home point. The current spindle location is now set to (0,0). When the SET HOME hot key is pressed the current absolute X and Y coordinate locations are stored in the controller' | The software reference point must be the material Home point. The current spindle location is now set to (0,0). When the SET HOME hot key is pressed the current absolute X and Y coordinate locations are stored in the controller' | ||
| We call this the temporary home because this position will be lost when the machines is switched off. | We call this the temporary home because this position will be lost when the machines is switched off. | ||
| - | \\ **Return to [[: | + | \\ **Return to [[: |
| + | **Continue to [[: | ||
en/x300/set_home_key.1664098446.txt.gz · Last modified: 2022/09/25 11:34 by erik.ketele
