Differences

This shows you the differences between two versions of the page.

--- en:x300:set_home_key [2022/09/25 11:27]
erik.ketele
+++ en:x300:set_home_key [2023/05/17 10:05] (current)
@@ Line 9: / Line 9: @@
   * Press the JOG ARROWS {{:en:x300:key_left.png?20|}} {{:en:x300:key_right.png?20|}} {{:en:x300:key_up.png?20|}} {{:en:x300:key_dn.png?20|}} keys to place the CENTER OF THE CUTTER over the rear left corner of the material.
-  * Press the SET HOME hot key.
+  * Press the SET HOME {{:en:x300:key_sethome.png?20|}} hot key.
   * Keypad Displays "Set home position here?"
-  * Press ENTER to accept.
+  * Press ENTER {{:en:x300:key_enter.png?20|}} to accept.
   * Keypad Display "Home 0 Set."
-=== Notes: ===
+=== Note: ===
-The software reference point must be the material Home point. The current spindle location is now set to (0,0). When the SET HOME hot key is pressed the current absolute X and Y coordinate locations are stored in the controller's memory. We call this the temporary home because this position will be lost when the machines is switched off.
+The software reference point must be the material Home point. The current spindle location is now set to (0,0). When the SET HOME hot key is pressed the current absolute X and Y coordinate locations are stored in the controller's memory.\\
+We call this the temporary home because this position will be lost when the machines is switched off.
- \\ **Return to [[:en:x300:keypad_overview|the keypad overview]].** \\ **Continue to [[:en:x300:table_of_contents|the table of contents]].**
+ \\ **Return to [[:en:x300:keypad_overview|the keypad overview]].** \\
+ **Continue to [[:en:x300:table_of_contents|the table of contents]].**

cyborg-engravers

User Tools

Site Tools

Differences

Page Tools