Differences

This shows you the differences between two versions of the page.

--- en:x300:rotation_on_off [2022/09/24 22:06]
erik.ketele created
+++ en:x300:rotation_on_off [2023/05/17 10:05] (current)
@@ Line 2: / Line 2: @@
 \\
-A very unique feature of the Cyborg X-300 is the ability for the user to choose between unidirectional and bidirectional engraving.\\
+Depending upon the kind of tool, a normal engraving cutter or a diamond drag cutter, the spindle motor has to rotate or not.\\
-This feature dramatically improves the engraving results in aluminium, steel and other more difficult to engrave materials.\\
+For normal engravings the spindle should always be rotating, but when diamond scratching in metals, the spindle motor should not rotate.\\
 \\
-{{:en:x300:bidirectional-red-green.png?80|}} If this icon is shown on the virtual pendent, every character or vector will be engraved in the preprogrammed direction, which is fine for most plastics.\\
+{{:en:x300:cutter_spinning.png?50|}}  If this icon is shown on the virtual pendent, The spindle will rotate. It will automatically start and stop at the end of every engraving job.\\
-{{:en:x300:bidirectional-green-green.png?80|}} If this icon is shown on the virtual pendent, every character or vector will be engraved in the preprogrammed direction.  At the end of each character the spindle will stay down in the material and run through the character again in the opposite direction.\\
+{{:en:x300:cutter_nospin.png?50|}} If this icon is shown on the virtual pendent, the spindle will not rotate during the engraving job.\\
 \\
+Clicking on the icon will alternate between the 2 possible choices.
 **Return to [[keypad_overview|the keypad overview]].**\\

cyborg-engravers

User Tools

Site Tools

Differences

Page Tools