en:x300:poor_engraving_results
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x300:poor_engraving_results [2022/09/28 16:30] erik.ketele |
en:x300:poor_engraving_results [2023/05/17 10:05] (current) |
||
|---|---|---|---|
| Line 9: | Line 9: | ||
| Check the following: | Check the following: | ||
| \\ | \\ | ||
| - | 1. Is there a timing belt between the spindle motor pulley | + | 1. Is your cutter sharp and adapted for the kind of material you want to engrave |
| - | 2. Does your virtual pendent on the computer screen show a cutter with a "green arrow" | + | 2. Are the XYZ feed speeds and the spindle RPM adapted for your material ?\\ |
| + | 3. Is the cutter | ||
| + | 4. When engraving aluminium or stainless, did you not forget to switch on the "bidirectional" {{:en:x300:bidirectional-green-green.png?40|}} function ?\\ | ||
| + | 5. Is your cutter knob still in good shape? A worn out cutter knob could cause the cutter to vibrate.\\ | ||
| + | 6. If your engraving depth is not equally deep everywhere, you need to check if the floating function is working correctly.\\ | ||
| + | 7. If the floating function works fine, please check the status of the nosecone.\\ | ||
| + | 8. If the engravings show different depts, or if you see shadows near the engraved characters, you may be engraving without vacuum cleaner. | ||
| - | **Continue to [[poor_engraving_results|trouble shooting, | + | **Continue to [[no_pc_connection|trouble shooting, |
| **Continue to [[: | **Continue to [[: | ||
en/x300/poor_engraving_results.1664375442.txt.gz · Last modified: 2022/09/28 16:30 by erik.ketele
