en:x300:pendent_registration
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x300:pendent_registration [2022/09/24 20:44] erik.ketele |
en:x300:pendent_registration [2025/04/17 16:10] (current) erik.ketele |
||
|---|---|---|---|
| Line 20: | Line 20: | ||
| Over the virtual pendent you will see a little window in which the following message is displayed: "I have read and understood the Operator’s Manual”. | Over the virtual pendent you will see a little window in which the following message is displayed: "I have read and understood the Operator’s Manual”. | ||
| - | | {{: | + | | {{: |
| - | This message is important!\\ | + | This message is important! \\ |
| - | By clicking OK you testify that you have actually read and that you have completely understood the contents of this manual.\\ | + | By clicking OK you testify that you have actually read and that you have completely understood the contents of this manual. \\ |
| - | Hence, if you have not read, or if you have not fully understood this entire manual, you should not click this OK button. If you have read and understood this manual, click the OK button.\\ | + | Hence, if you have not read, or if you have not fully understood this entire manual, you should not click this OK button. If you have read and understood this manual, click the OK button. \\ |
| After having done so, the window with the warning message disappears.</ | After having done so, the window with the warning message disappears.</ | ||
| - | |{{: | + | |{{: |
| + | In other words the machine has to find its limits and position itself over the top left corner of the engraving table. That is where the home position is. \\ | ||
| + | The home position is indicated with the coordinates (0,0). \\ | ||
| + | \\ | ||
| + | To home the machine press the (shift) and the (go home) keys one after another. \\ | ||
| + | If the machine’s protective cover was not closed when you try to home, the following will appear on your computer screen (see image on the left): \\ | ||
| + | \\ | ||
| + | Close the protective cover, the bitmap with the yellow arrow will disappear and you can restart the homing cycle by pushing | ||
| + | \\ | ||
| + | If you click OK without having closed the protective cover, the window with the image to close the lid will also disappear, \\ | ||
| + | but it will be displayed again when you re-try to home the machine. \\ | ||
| + | \\ | ||
| + | Hence remember that you can only home the machine with the protective cover closed.</ | ||
| ==== ==== | ==== ==== | ||
en/x300/pendent_registration.1664045091.txt.gz · Last modified: 2022/09/24 20:44 by erik.ketele
