Differences

This shows you the differences between two versions of the page.

--- en:x300:pendent_installation_standalone [2022/09/24 12:56]
erik.ketele
+++ en:x300:pendent_installation_standalone [2023/05/17 10:05] (current)
@@ Line 20: / Line 20: @@
 |{{:en:x300:installatie-2.png?400  |{afbeelding}}|- Click the “install” button, the software installs itself and at the end of the installation procedure you will see the following window:|
 |{{:en:x300:installatie-3.png?400  }}|- Then click the “Close” button. Your Cyborg machine software is now fully installed.|
-- Doubleclick on the "CyborgPendent-0.0.xx_x64.exe" file to start the installation procedure. When you run this file for the first time you will see a window similar to this one:
-- Click the “Next” button.- After a few seconds you will see this window on your pc screen:
-- Click the “install” button, the software installs itself and at the end of the installation procedure you will see the following window:
 ----

cyborg-engravers