en:x300:pendent_installation_standalone
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision
Previous revision
Next revision
|
Previous revision
|
en:x300:pendent_installation_standalone [2022/09/24 12:50]
erik.ketele [Installation] |
en:x300:pendent_installation_standalone [2023/05/17 10:05] (current)
|
| ===== Installation ===== | ===== Installation ===== |
| |
| |{{:en:x300:installatie-1.png?400 |{afbeelding}}|- Doubleclick on the "CyborgPendent-0.0.xx_x64.exe" file to start the installation procedure. When you run this file for the first time you will see a window similar to this one: | | |{{:en:x300:installatie-1.png?400 |{afbeelding}}| \\ - Doubleclick on the "CyborgPendent-0.0.xx_x64.exe" file to start the installation procedure. \\ When you run this file for the first time you will see a window similar to this one: \\ - Click the “Next” button.- After a few seconds you will see the following window on your pc screen:| |
| |{{:en:x300:installatie-2.png?400 |{afbeelding}}|- Click the “Next” button.- After a few seconds you will see this window on your pc screen: | | |{{:en:x300:installatie-2.png?400 |{afbeelding}}|- Click the “install” button, the software installs itself and at the end of the installation procedure you will see the following window:| |
| |{{:en:x300:installatie-3.png?400 }}|- Click the “install” button, the software installs itself and at the end of the installation procedure you will see the following window: | | |{{:en:x300:installatie-3.png?400 }}|- Then click the “Close” button. Your Cyborg machine software is now fully installed.| |
| | |
| - Doubleclick on the "CyborgPendent-0.0.xx_x64.exe" file to start the installation procedure. When you run this file for the first time you will see a window similar to this one: | |
| | |
| - Click the “Next” button.- After a few seconds you will see this window on your pc screen: | |
| | |
| - Click the “install” button, the software installs itself and at the end of the installation procedure you will see the following window: | |
| | |
| - Then click the “Close” button. Your Cyborg machine software is now fully installed. | |
| |
| ---- | ---- |
en/x300/pendent_installation_standalone.1664016642.txt.gz · Last modified: 2022/09/24 12:50 by erik.ketele
