en:x300:pendent_installation_standalone
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x300:pendent_installation_standalone [2022/09/20 14:01] erik.ketele [Installation] |
en:x300:pendent_installation_standalone [2023/05/17 10:05] (current) |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| Note: If you are not familiar with setting up Ethernet connections, | Note: If you are not familiar with setting up Ethernet connections, | ||
| - | |||
| ==== Preparations ==== | ==== Preparations ==== | ||
| Line 11: | Line 10: | ||
| - Boot your computer as administrator with full administrator rights. | - Boot your computer as administrator with full administrator rights. | ||
| - Make sure all firewalls and virus scanners are disabled. | - Make sure all firewalls and virus scanners are disabled. | ||
| - | - Give your pc the following fixed IP-address: 172.22.2.101. Our Cyborg machine is preprogrammed with the following fixed IP-address: | + | - Give your pc the following fixed IP-address: 172.22.2.101. Our Cyborg machine is preprogrammed with the following fixed IP-address: \\ 172.22.2.100 and the following netmask: 255.255.255.0. |
| - Put the usb stick which was supplied with the Cyborg X-300 in the pc. | - Put the usb stick which was supplied with the Cyborg X-300 in the pc. | ||
| - Create a folder on your C-drive, and name it “Cyborg”. | - Create a folder on your C-drive, and name it “Cyborg”. | ||
| Line 18: | Line 17: | ||
| ===== Installation ===== | ===== Installation ===== | ||
| - | - Doubleclick on the " | + | |{{: |
| + | |{{: | ||
| + | |{{: | ||
| - | - Click the “Next” button.- After a few seconds you will see this window on your pc screen: | + | ---- |
| - | - Click the “install” button, the software installs itself and at the end of the installation procedure you will see the following window: {{:en:x300:installatie-2.png? | + | **Continue to [[:en:x300:pendent_registration|registering the virtual pendent software]].** \\ **Continue to [[:en:x300:table_of_contents|the table of contents]].** |
| - | {{:en:x300:installatie-3.png? | + | |
| - | + | ||
| - | - Then click the “Close” button. Your Cyborg machine software is now fully installed. | + | |
| - | + | ||
| - | ---- | + | |
| - | **Continue to [[: | ||
| - | [[pendent_installation_network|8446546546546]] | ||
en/x300/pendent_installation_standalone.1663675287.txt.gz · Last modified: 2022/09/20 14:01 by erik.ketele
