Differences

This shows you the differences between two versions of the page.

--- en:x300:pendent_installation_standalone [2022/09/20 13:55]
erik.ketele [Installing the Cyborg Pendent Software on a standalone pc with a fixed IP-address.]
+++ en:x300:pendent_installation_standalone [2023/05/17 10:05] (current)
@@ Line 2: / Line 2: @@
 Note: If you are not familiar with setting up Ethernet connections, you should get help from a qualified IT-specialist.
 ==== Preparations ====
@@ Line 11: / Line 10: @@
   - Boot your computer as administrator with full administrator rights.
   - Make sure all firewalls and virus scanners are disabled.
-  - Give your pc the following fixed IP-address: 172.22.2.101. Our Cyborg machine is preprogrammed with the following fixed IP-address:\\ 172.22.2.100 and the following netmask: 255.255.255.0.
+  - Give your pc the following fixed IP-address: 172.22.2.101. Our Cyborg machine is preprogrammed with the following fixed IP-address: \\ 172.22.2.100 and the following netmask: 255.255.255.0.
   - Put the usb stick which was supplied with the Cyborg X-300 in the pc.
   - Create a folder on your C-drive, and name it “Cyborg”.
@@ Line 18: / Line 17: @@
 ===== Installation =====
-- Doubleclick on the "CyborgPendent-0.0.xx_x64.exe" file to start the installation procedure. When you run this file for the first time you will see a window similar to this one:{{:en:x300:installatie-1.png?400  |{afbeelding}}
+|{{:en:x300:installatie-1.png?400  |{afbeelding}}| \\ - Doubleclick on the "CyborgPendent-0.0.xx_x64.exe" file to start the installation procedure. \\ When you run this file for the first time you will see a window similar to this one: \\ - Click the “Next” button.- After a few seconds you will see the following window on your pc screen:|
+|{{:en:x300:installatie-2.png?400  |{afbeelding}}|- Click the “install” button, the software installs itself and at the end of the installation procedure you will see the following window:|
-- Click the “Next” button.- After a few seconds you will see this window on your pc screen:
+|{{:en:x300:installatie-3.png?400  }}|- Then click the “Close” button. Your Cyborg machine software is now fully installed.|
-- Click the “install” button, the software installs itself and at the end of the installation procedure you will see the following window: {{:en:x300:installatie-2.png?400  |{afbeelding}}\\
-{{:en:x300:installatie-3.png?400  }}
-- Then click the “Close” button. Your Cyborg machine software is now fully installed.
 ----
-**Continue to [[:en:x300:table_of_contents|the table of contents]].**
+**Continue to [[:en:x300:pendent_registration|registering the virtual pendent software]].** \\ **Continue to [[:en:x300:table_of_contents|the table of contents]].**

cyborg-engravers

User Tools

Site Tools

Differences

Page Tools