en:x300:pendent_installation_network
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x300:pendent_installation_network [2022/09/19 15:55] erik.ketele |
— (current) | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Registering and starting the Cyborg pendent software. ====== | ||
| - | |||
| - | {{: | ||
| - | Double click on the icon and the virtual Cyborg keypad will be opened. Position it on the right hand side of your computer screen so that it fills the complete display height.\\ | ||
| - | Over the virtual pendent you will see a little window in which the following message is displayed: "I have read and understood the Operator’s Manual”.\\ | ||
| - | {{: | ||
| - | This message is important!\\ | ||
| - | By clicking OK you testify that you have actually read and that you have completely understood the contents of this manual.\\ | ||
| - | Hence, if you have not read, or if you have not fully understood this entire manual, you should not click this OK button.\\ | ||
| - | If you have read and understood this manual, click the OK button. After having done so, the window with the warning message disappears. | ||
| - | |||
| - | ==== Registering the virtual pendent software ==== | ||
| - | |||
| - | In order to be able to use the virtual pendent software, it has to be registered. In the top bar of the Cyborg virtual pendent right click on the “?”, and then on the “register” menu option. | ||
| - | |||
| - | ==== : | ||
| - | |||
| - | ==== ==== | ||
| - | |||
| - | ==== Installation ==== | ||
| - | |||
| - | From here on, follow the instructions under [[: | ||
| - | |||
| - | **Continue to [[: | ||
| - | |||
en/x300/pendent_installation_network.1663595731.txt.gz · Last modified: 2022/09/19 15:55 by erik.ketele
