Differences

This shows you the differences between two versions of the page.

--- en:x300:pause_button [2022/09/21 22:06]
erik.ketele
+++ en:x300:pause_button [2023/10/20 10:19] (current)
jan.vangelder
@@ Line 1: / Line 1: @@
 ====== Using the pause button ======
+----
 To pause the engraving cycle in the middle of a job, you can click the “Pause” {{:en:x300:pause.png?50|}} button on your virtual keypad. The spindle will go up, the XY moves will stop, the spindle will stop rotating and the “resume” [[:user:jan.vangelder:x300:en:20x20.png?id=en%3Ax300%3Apause_button&media=user:jan.vangelder:x300:en:20x20.png|{{:user:jan.vangelder:x300:en:20x20.png?18}}]] button will be displayed.
@@ Line 7: / Line 9: @@
 Clicking the Resume {{:en:x300:resume.png?50|}} button will resume the engraving at the right spot, even if you did jog the spindle to another location during the pause.
+----
+**Continue to [[cancel_a_job|cancelling an engraving job]].**\\
 **Continue to [[:en:x300:table_of_contents|the table of contents]].**

cyborg-engravers