en:x300:no_pc_connection
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x300:no_pc_connection [2022/09/28 16:51] erik.ketele |
en:x300:no_pc_connection [2023/10/20 12:22] (current) jan.vangelder |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ===== No connection between machine and computer ===== | ===== No connection between machine and computer ===== | ||
| + | |||
| + | ---- | ||
| + | |||
| **__general rules: | **__general rules: | ||
| 1) Your pc has to have a dedicated ethernet port to hook up the engraver\\ | 1) Your pc has to have a dedicated ethernet port to hook up the engraver\\ | ||
| Line 8: | Line 11: | ||
| \\ | \\ | ||
| 1. Has your PC been switched on and has the X-300 engraver been switched on?\\ | 1. Has your PC been switched on and has the X-300 engraver been switched on?\\ | ||
| - | 2. Is your pendent software running? | + | 2. Check if the ethernet settings of your pc are still ok (see IP-address hereabove).\\ |
| - | 3. Has the pendent software been registered? | + | 3. Is your virtual |
| - | 4. If these conditions are fullfilled | + | 4. Has the pendent software been registered? |
| - | 5. Is your cutter knob still in good shape? A worn out cutter knob could cause the cutter to vibrate.\\ | + | 5. If these conditions are fulfilled |
| - | 6. If your engraving depth is not equally deep everywhere, you need to check if the floating function is working correctly.\\ | + | |
| - | 7. If the floating function works fine, please check the status of the nosecone.\\ | + | |
| - | 8. If the engravings show different depts, or if you see shadows near the engraved characters, you may be engraving without vacuum cleaner. | + | |
| **Continue to [[no_pc_connection|trouble shooting, there is no connection between pc and machine]].**\\ | **Continue to [[no_pc_connection|trouble shooting, there is no connection between pc and machine]].**\\ | ||
| **Continue to [[: | **Continue to [[: | ||
en/x300/no_pc_connection.1664376687.txt.gz · Last modified: 2022/09/28 16:51 by erik.ketele
