en:x300:no_pc_connection
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x300:no_pc_connection [2022/09/28 16:43] erik.ketele |
en:x300:no_pc_connection [2023/10/20 12:22] (current) jan.vangelder |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ===== No connection between machine and computer ===== | ===== No connection between machine and computer ===== | ||
| + | |||
| + | ---- | ||
| + | |||
| **__general rules: | **__general rules: | ||
| - | 1) Make sure you only use sharp cutters.\\ | + | 1) Your pc has to have a dedicated ethernet port to hook up the engraver\\ |
| - | 2) Make sure your cutters | + | 2) You have to use the supplied CAT 6A ethernet cable. |
| - | 3) Always try not to engrave deeper than necessary. | + | 3) The ethernet port in your pc has to be configured with the following fixed IP-address: 172.22.2.101, netmask 255.255.255.0\\ |
| - | 4) If you have to colour fill engravings, e.g. in aluminium, the engraving depth needs to be be 0.3 mm.\\ | + | |
| Check the following: | Check the following: | ||
| \\ | \\ | ||
| - | 1. Is your cutter sharp and adapted for the kind of material you want to engrave | + | 1. Has your PC been switched on and has the X-300 engraver been switched on?\\ |
| - | 2. Are the XYZ feed speeds and the spindle RPM adapted for your material ?\\ | + | 2. Check if the ethernet settings of your pc are still ok (see IP-address hereabove).\\ |
| - | 3. Is the cutter width adapted to the character height in combination with the used font ? For most single line fonts you need a cutter width about 1/8 to 1/10 of the character height.\\ | + | 3. Is your virtual pendent software running?\\ |
| - | 4. When engraving aluminium or stainless, did you not forget to switch on the " | + | 4. Has the pendent software been registered?\\ |
| - | 5. Is your cutter knob still in good shape? A worn out cutter knob could cause the cutter to vibrate.\\ | + | 5. If these conditions are fulfilled |
| - | 6. If your engraving depth is not equally deep everywhere, | + | |
| - | 7. If the floating function works fine, please check the status of the nosecone.\\ | + | |
| - | 8. If the engravings show different depts, or if you see shadows near the engraved characters, you may be engraving without vacuum cleaner. A vacuum cleaner is a must!\\ | + | |
| **Continue to [[no_pc_connection|trouble shooting, there is no connection between pc and machine]].**\\ | **Continue to [[no_pc_connection|trouble shooting, there is no connection between pc and machine]].**\\ | ||
| **Continue to [[: | **Continue to [[: | ||
en/x300/no_pc_connection.1664376186.txt.gz · Last modified: 2022/09/28 16:43 by erik.ketele
