en:x300:materials_rpm_feed
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x300:materials_rpm_feed [2022/09/21 12:07] erik.ketele [Diamond scratching] |
en:x300:materials_rpm_feed [2023/10/20 10:16] (current) jan.vangelder |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Selection of materials, rotation and feed speeds ====== | ====== Selection of materials, rotation and feed speeds ====== | ||
| + | |||
| + | ---- | ||
| For every engravable material there is an ideal feed (mm/sec) and speed (rpm) which yields an optimal engraving result. When engraving, try to respect each and every one of the following principles: | For every engravable material there is an ideal feed (mm/sec) and speed (rpm) which yields an optimal engraving result. When engraving, try to respect each and every one of the following principles: | ||
| - | - Only use sharp cutters. If your engraving results get poor, more than likely your cutter is dull, or has a broken tip. Use a good magnifying glass to regularly check the cutting edges of your cutters. | + | - Use only sharp cutters. If your engraving results get poor, more than likely your cutter is dull, or has a broken tip. Use a good magnifying glass to regularly check the cutting edges of your cutters. |
| - Only use high quality micro-carbide cutters. | - Only use high quality micro-carbide cutters. | ||
| - Different materials may require different cutting angles. Make sure your cutter has the right angles for the material you intend to cut. | - Different materials may require different cutting angles. Make sure your cutter has the right angles for the material you intend to cut. | ||
| Line 35: | Line 37: | ||
| * Glass | * Glass | ||
| + | **Continue to [[two_way_engraving_metals|bidirectional engraving]].**\\ | ||
| **Continue to [[: | **Continue to [[: | ||
en/x300/materials_rpm_feed.1663754840.txt.gz · Last modified: 2022/09/21 12:07 by erik.ketele
