Differences

This shows you the differences between two versions of the page.

--- en:x300:jog_y_keys [2022/09/25 22:08]
erik.ketele
+++ en:x300:jog_y_keys [2023/05/17 10:05] (current)
@@ Line 1: / Line 1: @@
-====== Jog spindle up to the rear =======
+====== Jogging the spindle =======
-{{:en:x300:key_zup.png?50|}}\\
-Press and hold the Z-AXIS JOG ARROW {{:en:x300:key_zup.png?30|}} to raise the spindle.\\
+| {{:en:x300:key_up.png?50|}} | **Jog to the left (X-) and to the back (Y+)**\\ Press the {{:en:x300:key_up.png?20|}} key to jog the spindle to the rear.\\ The jog speed is determined jog speed bar setting.  |
+| {{:en:x300:key_left.png?50|}} | **Jog to the right (X+) and to the back (Y+)**\\ Press the {{:en:x300:key_left.png?20|}} key to jog the spindle to the left.\\ The jog speed is influenced by the jog speed bar setting.  |
+| {{:en:x300:key_right.png?50|}} | **Jog to the left (X-) and to the front (Y-)**\\ Press the {{:en:x300:key_right.png?20|}} key to jog the spindle to the right.\\ The jog speed is determined by the jog speed bar setting.  |
+| {{:en:x300:key_dn.png?50|}} | **Jog to the right (X+) and to the front (Y-)**\\ Press the {{:en:x300:key_dn.png?20|}} key to jog the spindle to the front.\\ The jog speed is influenced by the jog speed bar setting.  |
+\\
 Use the jog speed bar to change the speed {{:en:x300:snail-rabbit.jpg?200|}}. Click on the rabbit or on the turtle, or click on the dial.

cyborg-engravers