Differences

This shows you the differences between two versions of the page.

--- en:x300:increase_rotation_speed_key [2022/09/25 11:09]
erik.ketele
+++ en:x300:increase_rotation_speed_key [2023/05/17 10:05] (current)
@@ Line 1: / Line 1: @@
 ====== Increase spindle rotation speed. ======
-This input allows you to increase the machine’s XY travel and cut speeds to a maximum of 150%. This affects the feedrate or cut speed when the cutter is moving through the material. When the machine is executing a rapid move, moving above the material, the feedrate override has no effect.
+{{:en:x300:key_rpmincrease.png?50|}}\\
+\\
+This input allows you to increase the RPM of the spindle to the maximum of 20000 RPM.\\
+Press the SPINDLE RPM OVERRIDE {{:en:x300:key_rpmincrease.png?30|}} hot key to increase the Spindle RPM by 100 rpm increments.\\
+Hold the SPINDLE RPM OVERRIDE {{:en:x300:key_rpmincrease.png?30|}} hot key to increase the Spindle RPM in 1000 rpm increments.\\
+The Spindle RPM can also be increased while a file is being executed.\\
+The current Spindle RPM will be displayed on the Keypad Control Panel as ####"RPM".\\
-The cut speed will be displayed on the Keypad Control Panel as a percentage "%Feed" and as a real speed in “mm/s (XY)”. The feedrate override will determine the amount that the cut speed will be adjusted by.
+**Note:**
+When the system receives a new spindle speed command (automatically while a file is being executed or manually using the hot keys), the spindle speed will be set to that value.
-When a file is being executed on the machine pressing the INCREASE CUT SPEED   hot key will increase the feedrate in 1% increments.
-Holding the INCREASE CUT SPEED   hot key increases the feedrate at an increasingly faster rate.
+\\
+**Return to [[keypad_overview|the keypad overview]].**\\
+**Continue to [[:en:x300:table_of_contents|the table of contents]].**

cyborg-engravers

User Tools

Site Tools

Differences

Page Tools