Differences

This shows you the differences between two versions of the page.

--- en:x300:increase_cut_speed_key [2022/09/25 10:51]
erik.ketele
+++ en:x300:increase_cut_speed_key [2025/03/11 21:36] (current)
erik.ketele
@@ Line 1: / Line 1: @@
 ====== Increase cut speed ======
-{{:en:x300:key_feedincrease.png?50|}}\\
+{{:en:x300:key_feedincrease.png?50}}\\
 This input allows you to increase the machine’s XY travel and cut speeds to a maximum of 150%.\\
 This affects the feedrate or cut speed when the cutter is moving through the material. When the machine is executing a rapid move, moving above the material,\\
@@ Line 7: / Line 7: @@
 The feedrate override will determine the amount that the cut speed will be adjusted by.
-When a file is being executed on the machine pressing the INCREASE CUT SPEED {{:en:x300:key_feedincrease.png?30|}} hot key will increase the feedrate in 1% increments.
+When a file is being executed on the machine pressing the INCREASE CUT SPEED {{:en:x300:key_feedincrease.png?30}}hot key will increase the feedrate in 1% increments.
-Holding the INCREASE CUT SPEED {{:en:x300:key_feedincrease.png?30|}} hot key increases the feedrate at an increasingly faster rate.
+Holding the INCREASE CUT SPEED {{:en:x300:key_feedincrease.png?30}}hot key increases the feedrate at an increasingly faster rate.\\
 \\
-\\
+**Return to [[:en:x300:keypad_overview|the keypad overview]].** \\
-**Return to [[keypad_overview|the keypad overview]].**\\
 **Continue to [[:en:x300:table_of_contents|the table of contents]].**

cyborg-engravers