en:x300:fixing_engraving_material
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x300:fixing_engraving_material [2022/09/18 13:39] erik.ketele [Using the optional vacuum table] |
en:x300:fixing_engraving_material [2023/05/17 10:05] (current) |
||
|---|---|---|---|
| Line 27: | Line 27: | ||
| The optional vacuum table can replace the standard flat engraving table. It is supplied with spunge rubber cord to delimit the vacuum zone. under this phenolic table there is a compressed air connection. the vacuum hose goes from there to either a vacuum pump or a vacuum converter, both of which have to be provided by the customer (hense they are not included with the vacuum table). | The optional vacuum table can replace the standard flat engraving table. It is supplied with spunge rubber cord to delimit the vacuum zone. under this phenolic table there is a compressed air connection. the vacuum hose goes from there to either a vacuum pump or a vacuum converter, both of which have to be provided by the customer (hense they are not included with the vacuum table). | ||
| + | **Continue to [[tool_setup|setting up a tool]].**\\ | ||
| **Continue to [[: | **Continue to [[: | ||
en/x300/fixing_engraving_material.1663501181.txt.gz ยท Last modified: 2022/09/18 13:39 by erik.ketele
