en:x300:electronics_cover_removal
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x300:electronics_cover_removal [2022/08/09 16:02] jan.vangelder |
en:x300:electronics_cover_removal [2023/05/17 10:05] (current) |
||
|---|---|---|---|
| Line 29: | Line 29: | ||
| * Now you can slide Y-axis belt cover on the left hand side off and put it to the side along with the screws, as shown in the picture on the right.{{ : | * Now you can slide Y-axis belt cover on the left hand side off and put it to the side along with the screws, as shown in the picture on the right.{{ : | ||
| - | \\ \\ \\ \\ \\ \\ \\ \\ | + | \\ \\ \\ \\ \\ \\ \\ |
| ==== Step 3 ==== | ==== Step 3 ==== | ||
| Line 42: | Line 42: | ||
| * Now you can slide Y-axis belt cover on the right hand side and put it to the side together with the screws and the other belt cover. | * Now you can slide Y-axis belt cover on the right hand side and put it to the side together with the screws and the other belt cover. | ||
| + | |||
| + | \\ \\ \\ \\ | ||
| ==== Step 4 ==== | ==== Step 4 ==== | ||
| - | * Remove the four button head M4 screws on the right of the X-300 (indicated | + | * Remove the four button head M4 screws on the right of the machine |
| - | * Remove the three button | + | * Remove the three button |
| + | |||
| + | \\ \\ \\ \\ \\ \\ \\ \\ \\ | ||
| ==== Step 5 ==== | ==== Step 5 ==== | ||
| - | * Remove the three M4 buttonhead screws at the rear of the machine, indicated by a green arrow in the image on the right. | + | * Remove the three M4 buttonhead screws at the rear of the machine, indicated by a green arrow in the image on the right.{{ : |
| - | * Remove the four M5 buttonhead screws at the front of the large electronics cover (see image below right). | + | \\ \\ \\ \\ \\ \\ \\ \\ \\ \\ \\ \\ |
| - | * The large electronics cover is now free, but in order to be able to remove it, two little screws have to be removed, which fix the end of the e-chain to the frame. First gently cut loose the 2 straps which fix the cables to thee-chain. (see images below). | + | |
| + | |||
| + | | ||
| + | |||
| + | \\ \\ \\ \\ \\ \\ \\ \\ \\ \\ \\ | ||
| ==== Step 6 ==== | ==== Step 6 ==== | ||
| - | * Gently lift the cover up by the 2 lips, one on the left of the cover and one on the right (see image on the right). | + | * Gently lift the cover up by the 2 lips, one on the left of the cover and one on the right (see image on the right). |
| * Sometimes it is a bit difficult to lift up the right back end of the cover. Slide a finger at the right under the cover and move towards the rear, then pull it up. | * Sometimes it is a bit difficult to lift up the right back end of the cover. Slide a finger at the right under the cover and move towards the rear, then pull it up. | ||
| - | | + | |
| + | | ||
en/x300/electronics_cover_removal.1660053766.txt.gz · Last modified: 2022/08/09 16:02 by jan.vangelder
