Differences

This shows you the differences between two versions of the page.

--- en:x300:dust_extraction_key [2022/09/24 21:32]
erik.ketele
+++ en:x300:dust_extraction_key [2025/04/21 21:03] (current)
erik.ketele
@@ Line 1: / Line 1: @@
 ===== Vacuum cleaner for dust extraction =====
-{{:en:x300:vac-aux_uitgangen.jpg?600|}}\\
+{{:en:x300:vac-aux_uitgangen.jpg?600}}\\
 \\
 The Cyborg X-300 should always be used with a dust extractor\\
 The X-300 controller can switch a vacuum cleaner on and off automatically at the beginning and at the end of an engraving job.\\
-To do so there is a dedicated 24 VDC outlet at the rear of the machine.  In fact there are 2 identical outlets.\\
+To do so there is a dedicated 24 VDC outlet at the rear of the machine. In fact there are 2 identical outlets.\\
 The lower one is meant to connect the vacuum cleaner.\\
 \\
-{{:en:x300:stofzuiger-groen.jpg?60|}} If this icon is shown on the virtual pendent, the vacuum cleaner outlet will be powered.\\
+{{:en:x300:stofzuiger-groen.jpg?60}}If this icon is shown on the virtual pendent, the vacuum cleaner outlet will be powered.\\
-{{:en:x300:stofzuiger-rood.jpg?60|}} If this icon is shown on the virtual penden, the vacuum outlet will not be powered.\\
+{{:en:x300:stofzuiger-rood.jpg?60}}If this icon is shown on the virtual penden, the vacuum outlet will not be powered.\\
 \\
-{{:en:x300:dsc_9147.png?300|}}\\Every X-300 comes with a short cable with plug to put in the "dust collector" output.\\
+{{:en:x300:dsc_9147.png?300}}\\
+Every X-300 comes with a short cable with plug to put in the "dust collector" outlet.\\
 The purpose is to switch on and off a 24 VDC relay which in turn can switch a vacuum cleaner on and off.\\
+\\
+Clicking on the icon will alternate between the 2 possible choices.
+**Return to [[:en:x300:keypad_overview|the keypad overview]].** \\
+**Continue to [[:en:x300:table_of_contents|the table of contents]].**

cyborg-engravers

User Tools

Site Tools

Differences

Page Tools