en:x300:dust_extraction_key
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x300:dust_extraction_key [2022/09/24 21:26] erik.ketele |
en:x300:dust_extraction_key [2025/04/21 21:03] (current) erik.ketele |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ===== Vacuum cleaner for dust extraction ===== | ===== Vacuum cleaner for dust extraction ===== | ||
| + | {{: | ||
| + | \\ | ||
| The Cyborg X-300 should always be used with a dust extractor\\ | The Cyborg X-300 should always be used with a dust extractor\\ | ||
| The X-300 controller can switch a vacuum cleaner on and off automatically at the beginning and at the end of an engraving job.\\ | The X-300 controller can switch a vacuum cleaner on and off automatically at the beginning and at the end of an engraving job.\\ | ||
| - | To do so there is a dedicated 24 VDC outlet at the rear of the machine. | + | To do so there is a dedicated 24 VDC outlet at the rear of the machine. In fact there are 2 identical outlets.\\ |
| The lower one is meant to connect the vacuum cleaner.\\ | The lower one is meant to connect the vacuum cleaner.\\ | ||
| - | {{: | ||
| - | {{: | ||
| \\ | \\ | ||
| - | {{:en:x300:vac-aux_uitgangen.jpg?200|}} | + | {{:en:x300:stofzuiger-groen.jpg?60}}If this icon is shown on the virtual pendent, the vacuum cleaner outlet will be powered.\\ |
| + | {{: | ||
| + | \\ | ||
| + | {{: | ||
| + | Every X-300 comes with a short cable with plug to put in the "dust collector" | ||
| + | The purpose is to switch on and off a 24 VDC relay which in turn can switch a vacuum cleaner on and off.\\ | ||
| + | \\ | ||
| + | Clicking on the icon will alternate between the 2 possible choices. | ||
| + | |||
| + | **Return to [[: | ||
| + | **Continue to [[: | ||
en/x300/dust_extraction_key.1664047590.txt.gz · Last modified: 2022/09/24 21:26 by erik.ketele
