Differences

This shows you the differences between two versions of the page.

--- en:x300:decrease_cut_speed_key [2022/01/06 14:18]
127.0.0.1 external edit
+++ en:x300:decrease_cut_speed_key [2023/05/17 10:05] (current)
@@ Line 1: / Line 1: @@
 ====== Decrease cut speed ======
-This input allows you to decrease the machine’s XY travel and cut speeds to a minimum of 1%. This affects the feedrate or cut speed when the cutter is moving through the material. When the machine is executing a rapid move, moving above the material, the feedrate override has no effect.
+{{:en:x300:key_feeddecrease.png?50|}}\\
+This input allows you to decrease the machine’s XY travel and cut speeds to a minimum of 1%. This affects the feedrate or cut speed when the cutter is moving through the material.\\
+When the machine is executing a rapid move, moving above the material, the feedrate override has no effect.
 The cut speed will be displayed on the Keypad Control Panel as a percentage "%Feed" and as a real speed in “mm/s (XY)”. The feedrate override will determine the amount that the cut speed will be adjusted by.
-When a file is being executed on the machine pressing the DECREASE CUT SPEED   hot key will decrease the feedrate in 1% increments.
+When a file is being executed on the machine pressing the DECREASE CUT SPEED {{:en:x300:key_feeddecrease.png?30|}} hot key will decrease the feedrate in 1% increments.
-Holding the DECREASE CUT SPEED   hot key decreases the feedrate at an increasingly faster rate.
+Holding the DECREASE CUT SPEED {{:en:x300:key_feeddecrease.png?30|}} hot key decreases the feedrate at an increasingly faster rate.
+\\
+**Return to [[keypad_overview|the keypad overview]].**\\
+**Continue to [[:en:x300:table_of_contents|the table of contents]].**

cyborg-engravers

User Tools

Site Tools

Differences

Page Tools