en:x300:configuring_the_pc_ethernet_port
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x300:configuring_the_pc_ethernet_port [2022/09/24 14:23] erik.ketele |
en:x300:configuring_the_pc_ethernet_port [2023/05/17 10:05] (current) |
||
|---|---|---|---|
| Line 13: | Line 13: | ||
| {{: | {{: | ||
| The PC ethernet adapter gets IP Address 172.22.2.101. The Cyborg X-300 is setup for 172.22.2.100.\\ | The PC ethernet adapter gets IP Address 172.22.2.101. The Cyborg X-300 is setup for 172.22.2.100.\\ | ||
| - | Press OK, now you can test if the network is working, click the Windows Start button, select all programs | + | Press OK, now you can test if the network is working, click the Windows Start button, select all programs => accessories=> |
| - | In the command prompt, enter “ping 172.22.2.100”, when the connection is OK, you should see: | + | In the command prompt, enter “ping 172.22.2.100” |
| + | {{: | ||
| + | \\ | ||
| + | If the connection would fail you will see the following: | ||
| + | {{: | ||
| + | If you see this problem, check your cable and your network settings again.\\ | ||
| + | Also check that the yellow led on the X-300 ethernet port is flashing at approximately 1Hz.\\ | ||
| + | ==== Set admin mode and switch off UAC ==== | ||
| + | The Cyborg pendent software needs real-time priority on Windows to control your machine correctly.\\ | ||
| + | This is only allowed with Admin rights, so make sure the user has Admin Rights, these screens are from Windows 7, they are similar on Windows 8, 10 and 11:\\ | ||
| + | Switch off “User Account Control” (=set to the lowest level)\\ | ||
| + | {{: | ||
| + | The Cyborg pendent application must be started as Administrator and the user starting it must have admin rights.\\ | ||
| + | Right click the mouse on the Cyborg pendent Icon and then select run as Administrator on Windows 7/ | ||
| + | {{: | ||
| + | \\ | ||
| + | \\ | ||
| - | + | **Continue to [[:en:x300:pendent_installation_standalone|pendent software | |
| - | + | **Continue to [[: | |
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
| - | **Continue to [[:en:x300:pendent_registration|registering the virtual | + | |
en/x300/configuring_the_pc_ethernet_port.1664022229.txt.gz · Last modified: 2022/09/24 14:23 by erik.ketele
