en:x300:choosing_z_modes
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x300:choosing_z_modes [2022/09/22 13:38] erik.ketele |
en:x300:choosing_z_modes [2023/05/17 10:05] (current) |
||
|---|---|---|---|
| Line 30: | Line 30: | ||
| - The images hereunder show the default map window when the surface button is hit with the “map” option active. The second image shows a typical set of data to perform a surface scan. In this case a surface of 50mm x 50mm will be scanned with one scan point every 10 mm. the Z-down move speed to find the surface in this case is 30 mm/sec and after having found the surface at each scan point the spindle in this case moves up 5 mm before moving to the following scan point. | - The images hereunder show the default map window when the surface button is hit with the “map” option active. The second image shows a typical set of data to perform a surface scan. In this case a surface of 50mm x 50mm will be scanned with one scan point every 10 mm. the Z-down move speed to find the surface in this case is 30 mm/sec and after having found the surface at each scan point the spindle in this case moves up 5 mm before moving to the following scan point. | ||
| - | {{: | + | {{: |
| + | |||
| + | **Continue to [[daily|daily maintenance]].**\\ | ||
| **Continue to [[: | **Continue to [[: | ||
en/x300/choosing_z_modes.1663846715.txt.gz · Last modified: 2022/09/22 13:38 by erik.ketele
