Differences

This shows you the differences between two versions of the page.

--- en:x300:choosing_z_modes [2022/09/22 13:23]
erik.ketele
+++ en:x300:choosing_z_modes [2023/05/17 10:05] (current)
@@ Line 28: / Line 28: @@
   - This system works for limited height differences and not for steep slopes. In any case, for safety reasons the Z safe lift has to be set higher than the height of the relief of the object to be mapped.
   - When using the “Map” option, make sure the black knurled spring pressure ring is screwed all the way up.
-  - The images on the left show the default map window when the surface button is hit with the “map” option active. The second image shows a typical set of data to perform a surface scan. In this case a surface of 150mm x 150mm will be scanned with one scan point every 10 mm. the Z-down move speed to find the surface in this case is 15 mm/sec and after having found the surface at each scan point the spindle in this case moves up 10 mm before moving to the following scan point.
+  - The images hereunder show the default map window when the surface button is hit with the “map” option active. The second image shows a typical set of data to perform a surface scan. In this case a surface of 50mm x 50mm will be scanned with one scan point every 10 mm. the Z-down move speed to find the surface in this case is 30 mm/sec and after having found the surface at each scan point the spindle in this case moves up 5 mm before moving to the following scan point.
+{{:en:x300:map_window_v2.png?250|}}   {{:en:x300:map_window_ingevuld_v2.png?250|}}
+**Continue to [[daily|daily maintenance]].**\\
 **Continue to [[:en:x300:table_of_contents|the table of contents]].**

cyborg-engravers

User Tools

Site Tools

Differences

Page Tools