en:x300:adjusting_feeds_and_speeds
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x300:adjusting_feeds_and_speeds [2022/09/21 21:59] erik.ketele |
en:x300:adjusting_feeds_and_speeds [2023/10/20 10:17] (current) jan.vangelder |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Adjusting feeds and speeds during cutting ====== | ====== Adjusting feeds and speeds during cutting ====== | ||
| + | |||
| + | ---- | ||
| Depending upon your engraving or routing software, feeds (mm/sec or m/min) and speeds (rpm) can or cannot be entered. If the resulting cnc files do not contain feeds and speeds, the system will use the speed and feed parameters which have been predefined in the virtual pendent' | Depending upon your engraving or routing software, feeds (mm/sec or m/min) and speeds (rpm) can or cannot be entered. If the resulting cnc files do not contain feeds and speeds, the system will use the speed and feed parameters which have been predefined in the virtual pendent' | ||
| Line 21: | Line 23: | ||
| | 150%| 75 mm/ | | 150%| 75 mm/ | ||
| + | **Continue to [[pause_button|the pause key]].**\\ | ||
| **Continue to [[: | **Continue to [[: | ||
en/x300/adjusting_feeds_and_speeds.1663790392.txt.gz · Last modified: 2022/09/21 21:59 by erik.ketele
