en:x200:spindle_not_rotating
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
en:x200:spindle_not_rotating [2025/04/23 10:42] erik.ketele created |
en:x200:spindle_not_rotating [2025/04/23 10:44] (current) erik.ketele |
||
|---|---|---|---|
| Line 7: | Line 7: | ||
| 1. Is there a timing belt between the spindle motor pulley and the spindle pulley ?\\ | 1. Is there a timing belt between the spindle motor pulley and the spindle pulley ?\\ | ||
| 2. Does your virtual pendent on the computer screen show a cutter with a "green arrow" ? {{: | 2. Does your virtual pendent on the computer screen show a cutter with a "green arrow" ? {{: | ||
| - | 3. Remove the spindle belt (which is located between the spindle pulley and the spindle motor pulley). | + | 3. Remove the spindle belt (which is located between the spindle pulley and the spindle motor pulley). |
| 4. In the above case (3.) check if a clogged spindle vacuum boot does not block the rotation. If that is the case remove the depth setting ring and clean the inside of it. Remember that it is necessary to always use a vacuum cleaner during operation. \\ | 4. In the above case (3.) check if a clogged spindle vacuum boot does not block the rotation. If that is the case remove the depth setting ring and clean the inside of it. Remember that it is necessary to always use a vacuum cleaner during operation. \\ | ||
en/x200/spindle_not_rotating.1745397770.txt.gz ยท Last modified: 2025/04/23 10:42 by erik.ketele
