en:x200:pendent_registration
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x200:pendent_registration [2025/04/17 16:15] erik.ketele |
en:x200:pendent_registration [2025/04/17 16:33] (current) erik.ketele |
||
|---|---|---|---|
| Line 16: | Line 16: | ||
| ==== Starting the virtual pendent software ==== | ==== Starting the virtual pendent software ==== | ||
| - | {{:en:x300:pendent_icon.png? | + | {{:en:x200:X200_pendent_icon.png? |
| Double click on the icon and the virtual Cyborg keypad will be opened. Position it on the right hand side of your computer screen so that it fills the complete display height.\\ | Double click on the icon and the virtual Cyborg keypad will be opened. Position it on the right hand side of your computer screen so that it fills the complete display height.\\ | ||
| Over the virtual pendent you will see a little window in which the following message is displayed: "I have read and understood the Operator’s Manual”. | Over the virtual pendent you will see a little window in which the following message is displayed: "I have read and understood the Operator’s Manual”. | ||
| Line 25: | Line 25: | ||
| Hence, if you have not read, or if you have not fully understood this entire manual, you should not click this OK button. If you have read and understood this manual, click the OK button. \\ | Hence, if you have not read, or if you have not fully understood this entire manual, you should not click this OK button. If you have read and understood this manual, click the OK button. \\ | ||
| After having done so, the window with the warning message disappears.</ | After having done so, the window with the warning message disappears.</ | ||
| - | |{{:en:x300:startup_kap_toedoen_v2.png? | + | |{{:en:x200:pendent_X200_CEsafety.png?310|CEsafety.png}}|<font 11.0pt/ |
| In other words the machine has to find its limits and position itself over the top left corner of the engraving table. That is where the home position is. \\ | In other words the machine has to find its limits and position itself over the top left corner of the engraving table. That is where the home position is. \\ | ||
| The home position is indicated with the coordinates (0,0). \\ | The home position is indicated with the coordinates (0,0). \\ | ||
en/x200/pendent_registration.1744899300.txt.gz · Last modified: 2025/04/17 16:15 by erik.ketele
